Skip to main content

CNC spindle repair in 3 to 5 working days · Call 704-SPINDLE (774-6353)

Northern Services Inc.

Matching a VFD to a high-frequency spindle motor

By Northern ServicesPublished on Reading time: 3 min read

Colombo RV 90/2 5hp MTC Spindle Motor

A high-frequency spindle motor is an induction motor that is fed at hundreds of hertz instead of sixty. The variable-frequency drive (VFD, or inverter) makes that supply, and it has to be chosen and set for the motor in front of it.

What to match

Maximum output frequency. A two-pole motor turns 60 rpm per hertz, so 18,000 rpm needs 300 Hz and 24,000 rpm needs 400 Hz. Many general-purpose drives stop at 120 or 400 Hz; a spindle drive has to reach the motor's maximum, and no further. Set the upper limit to the maximum speed on the motor print, not the drive's ceiling.

Current, not horsepower. Size the drive on the motor's rated current with headroom, and set the drive's motor-current parameter to the nameplate figure so the electronic overload protects the windings.

Voltage and the V/Hz curve. The motor plate gives voltage at rated frequency. Below that frequency the drive raises voltage in proportion to frequency (constant torque); above it the voltage is capped and torque falls away (constant power). Set the base frequency and voltage to the plate values, and enter the motor's other plate data if the drive asks for it.

Thermal protection. Many spindle motors carry a thermistor or a thermal switch in the windings. Wire it to the drive so a hot motor trips before it fails, and check that the trip actually works.

Braking. A spindle at 24,000 rpm stores real energy. Decelerating quickly needs a braking resistor or a drive that can absorb it; without one the drive trips on overvoltage during every stop.

Cabling. Shielded motor cable, shield grounded at the drive end, kept as short as practical and away from encoder and signal wiring. Long unshielded runs cause nuisance trips and can damage windings over time.

Symptoms of a mismatch

  • Trips on start or acceleration: current limit too low, ramp too short, or a motor larger than the drive.
  • Trips on stop: no braking resistor, or deceleration too fast.
  • Motor runs hot at low speed: V/Hz boost set too high, or a fan-cooled motor held at low rpm under load.
  • Weak at speed: base frequency set wrong, so voltage is capped too early.

Before you blame the spindle

A good share of "spindle" faults that reach us are drive settings, a cable or an encoder. If a motor has been rebuilt and the symptoms return the day it goes back on the machine, look at the drive parameters first. We are happy to talk it through on the phone before you ship anything.

Spindle down? Get it back in 3 to 5 working days.

Send the details and a few photos for a written quote, or call and talk it through.